Publicidad
Idiomas disponibles
Idiomas disponibles
3. Insert six leg screws
(3) into the sides
and underside
of the channel
(1). Tighten using
the Allen wrench.
Repeat on opposite
side. (See Figure 4)
4. Attach the side frames (4) to each end of channel
using four leg screws (3). Tighten with the Allen
wrench. (See Figure 5)
Figure 5
5. Place the tabletop (5) upside down on a clean,
smooth, non-marring surface to prevent scratching.
6. Place frame on tabletop (5). Adjust position of frame
so that it is centered on the tabletop. (See Figure 6)
NOTE: Frame is designed to fit tabletops that
are 24" or 30" wide. For 30" wide tabletops, side
frames will be approximately 3" from front and
back edges of tabletop. Figure 6 shows a 24"
tabletop (5).
NOTE: Lever (7) should be on front of tabletop,
opposite of the two grommet holes. Back of
tabletop has two grommet holes. Front of
tabletop is the opposite side.
7. Attach the side frames (4) and the channel (1) to
tabletop (5) using the drill and 14 wood screws (6).
(See Figure 6)
NOTE: Tabletop does not include pre-drilled
holes. Drill wood screws directly into tabletop
to attach base.
PAGE 2 OF 9
ASSEMBLY CONTINUED
Figure 4
3
1
4
Figure 6
6
3
8. Place lever (7) so
that the handle is
flush with the front
edge of table top
(5). Attach using the
drill and four wood
screws (6).
(See Figure 7)
NOTE: The lever will be located on the right side
of the table when flipped onto its feet.
9. Attach foot (8) to leg (2) using four foot screws (9).
Tighten using Allen wrench. Repeat on opposite side.
(See Figure 8)
10. Insert glides (10) into holes on bottom of feet (8).
(See Figure 8)
Figure 8
4
1
Figure 7
10
9
8
8
2
5
6
5
7
2
0323 IH-10242
Publicidad
