cecotec conga 8090 ULTRA Manual De Instrucciones página 37

2. Fixing
Charging base
Fig. 4.
1. Signal transmission area
2. Charging terminal
3. Charger input
2. BEFORE USE
- Take the product out of the box and remove all packaging materials.
- Make sure all parts and components are included and in good conditions. If any sign of
visible damage is observed, contact immediately with the official Technical Support
Service of Cecotec.
3. INSTALLATION
Robot and charging base installation. Fig. 5, 6.
- Connect the charging base to a power supply and store the remaining cable. It is important
to store the remaining cable at the bottom of the charging base to avoid it from being
dragged and disconnected.
- Place the charging base against the wall, leaving the safety distance indicated in the below
picture.
Note
Ensure a space of at least 1 m on both the left and right side of the charging base, and a space
of at least 2 m in front of it.
Warning
Do not expose the charging base to direct sunlight.
Hold down the power button for 3 seconds; when the light indicator turns on, place the robot
on the charging base. Fig. 7.
- Steady white light: On/Operating and/or charged.
- Oscillating orange light: charging and/or back home mode.
- Oscillating red light: Error
- Steady red light: tank or mop missing
ENGLISH
37