Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
-
When a cleaning cycle has been completed or the robot's battery is low, thanks to its Total
Surface 3.0 technology, the robot will also return to the charging base to avoid running
out of battery. Once the robot has recharged, it will resume cleaning from the point it has
stopped.
Recommendation
Remove the Wet & dry tank during charging.
Remote control.Fig. 12.
-
Scheduling
-
Power levels (Turbo/Normal/Eco)
-
Back home
-
Clock
-
Manual control
-
On/Pause
-
Edge mode
Remote control binding
-
If the robot does not respond to the remote control, follow the below steps:
-
Press the Edge mode button on the remote control for 5 seconds for the remote control to
enter pairing mode. The screen will display 8888.
-
The remote receiver will be activated in 5 seconds and will enter pairing mode. The remote
control's signal is received and the remote control returns to normal status. The display
will show pairing is completed.
-
If the pairing process is unsuccessful, the remote control will display 8888 and will exit the
pairing mode after 30 seconds.
The following modes and operations can be activated from the remote control.
Modes
The first time the robot is operated, it will map and save the whole house's map by means of its
laser before starting the cleaning cycle. Use the robot in Auto mode and Eco power level, this
way you will ensure the robot memorises the full map.
Note
Make sure the light indicator is lit up in blue before starting cleaning, indicating it is activated.
If not, press any button on the remote control to wake it up.
Automatic modeFig. 13.
-
Press the power button on the remote control for it to start cleaning automatically,
first a cleaning cycle in Edge mode and then another cycle in an organised zigzag
motion, recognising which areas it has cleaned and which ones it has not. The robot
40
Publicidad
