Denver IFM-90 Manual De Instrucciones página 9

INSTALLING THE BATTERIES
Remote Control Battery
The remote control requires one "CR2025 type" 3-volt
lithium battery, included. To extend the life of the original
battery we have inserted a small clear plastic spacer tab
between the lithium battery and the battery terminal. You
must remove this battery spacer tab before you can use
the remote control. To remove the tab, pull the tab out of
the battery compartment as shown.
When the operation of the remote control becomes
intermittent or unsatisfactory, replace the original battery
with a new 3-volt lithium battery.
1. Slide out the battery holder from the remote control
case.
2. Place one 3V CR2025 battery in the battery holder with
the print face up. If the battery is placed incorrectly the
remote control will not work.
3. Insert the battery holder into the battery slot.
BACK UP FUNCTION
If the AC supply is interrupted, the clock display and
radio preset stations will be lost and all settings will be
cancelled. To back up the clock and preset stations, insert
two AAA size batteries (not supplied) observing the
polarity marking in the battery compartment on the rear
of the unit. The back up battery will NOT backup iPod
settings.
Caution:
Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
Caution:
Risk of explosion if battery is replaced by an incorrect type. Dispose of batteries
according to the instructions.
- 6 -