Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM SOLUTION
1. WHY YOUR DRILL SUDDENLY STOPS
WHEN WORKING.
a)
They run at full power until they need charging. So if
your tool suddenly stops check your battery first. The
Li-ion battery is protected against deep discharging by
the "Discharging Protection System". When the battery
is empty, the machine is switched off by means of a
protective circuit, and the drill bit will be stop working.
b)
Overload protection. When overloaded, the motor
comes to a stop. Relieve the load on the machine
immediately and allow cooling for approx. 30 seconds
at the highest no-load speed.
c)
High temperature of the tool or battery. When the load
is too high or the allowable battery temperature of 75
°C is exceeded, the electronic control switches off
the power tool until the temperature is in the optimum
temperature range again.
2. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, having not used a battery pack for
a prolonged time will reduce the battery pack working time.
This can be corrected after several charge and discharge
operations by charging & working with your drill. Heavy
working conditions such as large screws into hard wood will
use up the battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack below 0
and above 30
C as this will affect performance.
o
MAINTENANCE
Remove the battery pack from the tool
before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.
EN
C
o
19
Publicidad
