AMS VICAM--EASYCAM-120 Manual página 2

1. PACKAGE CONTENT
Wireless screen
VICAM-AMS-MS7-WL
VICAM-AMS-MS9-WL
Articulated stand
monitor
VICAM-AMS-PM
Cigar lighter socket
power supply cable
VICAM-AMS-FM-WL
Important Notice
- We recommend that you have your equipment installed by a professional (cf. disclaimer section).
Failure to observe the instructions might result in damage to material and affect the proper functioning of the device. It
might also compromise people's safety. AMS will not assume responsibility if these instructions are not followed.
- MONITOR INSTALLATION :
Be careful not to disturb usual operations and the driver's visibility.
-Installation of the camera(s) :
Position your camera so as to avoid impact. Check the positioning of the sun visor and the slope of the camera.
Avoid attaching your camera to vibrating parts.
- Connection of the cables :
Before doing any work on the electrical components of your device. Always disconnect the negative terminal of the battery
(and possibly the spare battery too) to avoid any risk of short circuits. On disconnecting the negative terminal of the
battery, the volatile memories of the convenience electronics will lose their stored data.
2
AMS Diffusion - Rue des Galeries - ZA du Chevalement - 59286 Roost Warendin - FRANCE - Tél. +33 (0)3.27.94.44.44 - Fax. +33 (0)3 27 94 44 45
Email : contact@ams-diffusion.fr - www.ams-diffusion.com RCS DOUAI A 451 360 382 - CODE APE 4531Z - SIRET 451 360 382 00035 - TVA FR 55 451 360 382
Wireless camera
- battery
VICAM-AMS-EASYCAM-50
VICAM-AMS-EASYCAM-120
Remote control
VICAM-AMS-RM-WL
Power-supply cable
for wireless camera
VICAM-AMS-FC-WL
Email : contact@ams-diffusion.fr - www.ams-diffusion.com RCS DOUAI A 451 360 382 - CODE APE 4531Z - SIRET 451 360 382 00035 - TVA FR 55 451 360 382
2. INSTALLATION
Battery switched off
or
12/24 V
AUTOMATIC CONTROL CABLES
Connection for the automatic control of the display on camera 1
green (standby / monitor mode on) (+ 12/24V)
Connection for the automatic control of the display on camera 2
(standby / monitor mode on) (+ 12/24V)
white
Connection for the automatic control of the display on camera 3
(standby / monitor mode on) (+ 12/24V)
yellow
Connection for the automatic control of the display on camera 4
(standby / monitor mode on) (+ 12/24V)
blue
Take note : If the «automatic control» function is not used, do not connect the + 12 volt cables. This will prevent the moni-
tor's operation.
Comes in two versions: 50°/120°
The ON/OFF button and charge indicator
can be found on the side of the camera
Charging socket 5–12 volts
AMS Diffusion - Rue des Galeries - ZA du Chevalement - 59286 Roost Warendin - FRANCE - Tél. +33 (0)3.27.94.44.44 - Fax. +33 (0)3 27 94 44 45
Battery switched off
12/24 V
+
3