Publicidad
Idiomas disponibles
Idiomas disponibles
Starting operation
1. Set the spray nozzle to the "ON" po-
sition
2. Press the spray lever and spray the
window cleaning agent evenly onto
the surface to be cleaned from a dis-
tance of 8 in. (20 cm).
3. Loosen the dirt using the microfiber
wipe cover.
4. Set the trigger to the "ON" position.
The device switches on.
The remaining run time in minutes is
displayed.
10
Downloaded from
manualsnet.com
Operation
search engine
5. Pull the squeegee blade over the
surface to be cleaned to vacuum up
the waste water.
Note
Only work with the device until the
MAX mark of the waste water tank is
reached. Switch off the device and
empty the waste water tank (see chap-
ter Emptying the waste water tank).
Observe the following points to prevent
streaks appearing:
● Only glide the squeegee blade over
the surface to be cleaned, do not
press too hard.
● Hold the device at the correct angle
to the surface to be vacuumed. The
distance between the lower end of
the device and the surface should
be approx. 4 in. (10 cm).
● Use only a KÄRCHER detergent be-
cause this is specially developed for
use with the device.
● Spray a sufficient quantity of window
cleaner onto the surface so that it is
not too dry.
● Clean the squeegee blade regularly
(see chapter Cleaning the squee-
gee blade and suction nozzle).
● Replace the squeegee blade when
worn (see chapter Cleaning the
squeegee blade and suction noz-
zle).
● Do not perform cleaning work under
direct sunlight or when the weather
is too hot.
English
Publicidad
