Caution
Please read all instructions carefully before using this product.
Make sure that the voltage rating label on the type plate corresponds to your
main voltage. If not see your retailer and do not connect the appliance.
Never use the appliance unsupervised when in use.
If you have to leave even for a short moment please stop the appliance.
Keep out of reach of children and do not allow them to operate this appliance
Only use the appliance for domestic purposes and in the way indicated in
these instructions.
From time to time check the cord for damages. Never use the appliance if the
cord or any part of the appliance shows any signs of damage.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Make sure the connection cord does not touch any hot surfaces.
WARNING: In order to avoid overheating, do not cover the heater.
Keep the appliance at least 15cm (6inches) from walls and any other thing, to
permit a good air circulation.
Do not use the appliance outdoors
Do not use if you have wet hands.
Never use the appliance on or near hot surfaces.
Never move the appliance by pulling the cord.
Before cleaning the appliance, make sure it is unplugged from the power and
that it is completely cooled.
Do not clean the appliance with abrasive chemicals.
Never use accessories that are not recommended or supplied by the
manufacturer. It could cause danger to the user or damage to the appliance
Never route the mains cable beneath carpet.
Never use the heater to dry clothes or any other similar items.
The heater must not be located immediately below a socket outlet.
This heater must not be used with an extension lead.
Dot use this heater with a programmer, timer or any other device that switches
the heater on automatically, since a fire risk exists if the heater is covered or
positioned incorrectly.
Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied through an external switching device,
-1-