SOLAC Turbobat Power Instrucciones De Uso página 12

Downloaded by: pd-oliana on 12-09-2022 12:50 CEST
ENGLISH
AE2505
VACUUM CLEANER
DESCRIPTION
A. Accesories:
A1 Lance and multiuse brush
A2 Tube accessories support
A3 Extralong lance
B. Extension tube
C. Power supply
D. Motorized turbobrush Spiral
E. Filter
E1 Motor filter
E2 Outlet filter
F. Battery indicator
G. Button to open outlet filter
H. Body
I. Dust tank
J. Lithium batteries
K. Wall bracket and charging base
L. Button to open the lower lid of the tank.
M. Speed indicator button
N. Battery removal button
O. Button to remove the extension tube
P. ON/OFF and ECO/TURBO selector button
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Do not use the appliance if the parts or
accessories are not properly fitted.
- Do not use the appliance if the accessories
or consumables attached to it are defective.
Replace them immediately.
- Do not use the appliance to gather up water or
any other liquid.
- Do not use the appliance if the on/off switch
does not work.
- Respect the MAX level indicator.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Do not work on areas where there are metal
objects, such as nails and/or screws.
- Never vacuum hot or sharp objects (cigarette
butts, ashes, nails, etc.).
- Do not open the battery/ies under any
circumstances whatsoever.
- The battery/ies should be stored at a
temperature of below 40ºC.
- Never leave the appliance connected and
unattended if is not in use. This saves energy
and prolongs the life of the appliance.
- Do not use the appliance on any part of the
body of a person or animal.
- Do not use the appliance with pets or animals.
- Recharge the battery/ies only with the charger
supplied by the manufacturer. A charger that
is suitable for one type of battery may cause
explosion or fire hazard when used with other
battery/ies.
- Use the device only with the battery/ies for
which has been specifically designed. The
use of any other battery/ies s can cause an
explosion or fire hazard.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
ASSEMBLING THE WALL BRACKET:
- The appliance has a charging base (K) which
must be fixed to the wall.
- Fix the wall bracket as you think appropriate,
using plugs, screws, and adhesive...
- Make sure that the bracket is firmly fixed; it
should be able to support twice the weight of the
appliance.
- Fit the appliance into the wall support.
CHARGING THE BATTERY:
- Caution: A new battery is not fully charged and
must therefore be charged before the appliance
is used for the first time.
- Charge the battery at an atmospheric
temperature of between 4 and 40ºC.
- Connect the power supply in the product
connector located in rear part above the handle.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 4 to 5 hours are needed for a