Walter ICECUT 250 Auto Manual De Instrucciones página 18

15) FITTING THE CHUCK
1. The machine comes supplied with an Arbor Shank (48H591) & 13mm Chuck (39D008).
2. Insert 48H591 into Arbor Spindle (48H596), ensure a good and tight fit is achieved.
3. Insert 39D008 into 48H591, ensure a good and tight fit is achieved.
4. Replacing the chuck is the reverse sequence, by utilising 48H460 (Drift).
16) MAINTENANCE
In order to get the best life out of your Walter machine, always keep it in good working order.
A number of items must always be checked on Walter machines.
Before starting any job, always make sure the machine is in good working order and that there are no
damaged or loose parts. Any loose parts must be tightened.
Before proceeding with any maintenance work be certain that the power supply is disconnected.
Visual check of
machine for damage
Operation of machine
Check brush wear
Check magnetic base
Check alignment of the
machine
Check grease
Check armature
Visually check the machine for damage.
The machine must be checked before operation for any signs of damage that will affect the operation of
the machine. Particular notice must be taken to the mains cable, if the machine appears to be damaged
it should not be used, failure to do so may cause injury or death.
Check operation of the machine.
The machines operation must be checked to ensure that all components are working correctly.
Description Every operation 1 week
X
X
X
X
18
1 Month
X
X
X