Comunello Automation MAST SLIM Manual Del Usuario página 7

Thank you for choosing a COMUNELLO AUTOMATION
product.
This manual provides all the detailed information required for
the understanding and correct use of the equipment. It must
be read carefully at the time of purchase and consulted if
there are any doubts regarding its use or when maintenance
is required.
The manufacturer reserves the right to make any modifications
to the item and to this document without prior notice.
WARNINGS
Please read this manual carefully before beginning installation
and carry out the procedures as specified by the manufacturer.
This installation manual is only intended for professional
personnel.
Anything not expressly included in these instructions is
prohibited.
PRODUCT DESCRIPTION AND INTENDED USE
Extruded aluminium masts and sturdy base suitable for
housing photocells or other accessories, in situations where
walls are not available.
PRELIMINARY CHECKS
• Check that the item inside the packaging is intact and in
good condition.
• Ensure that the mast is secured to a solid foundation and is
positioned in a location that is easily accessible.
• Ensure that installation is outside the operating zone of the
gate as required by current regulations.
• Ensure the masts are positioned on parallel surfaces and
at the same height to allow for correct alignment of the
photocells.
INSTALLATION
• Secure the masts to the floor with suitable anchoring systems
or, in the case of fresh concrete, submerge the plate using
anchor bolts (Figs. A-B).
• To remove the protective cover, apply pressure to the sides
and remove it as shown in Figure 1.
• The DART SLIM photocell can be installed on the upper part.
• Proceed as shown in Figures 1 to 5.
• Securing screws for the accessories are included.
CONNECTIONS
Wiring must be routed internally along the mast to reach the
photocells or other accessories, transiting inside the supports.
DISPOSAL
A number of components of
be recycled while others, such
components must be disposed of in accordance with the
regulations in force in the country of installation.
A number of components may contain pollutants that must not
be released into the environment.
the item can
as electronic
43 mm
84 mm
A-1
Ø3.5x25 mm x4
AC - 860 (OPTIONAL KIT)
B-1
B-4
50 mm 39.5 mm
100 mm 69 mm
A-2 A-3
B-2 B-3
B-5 B-6
IXI
INDEX
DART
MAST
A-4
24H