Publicidad
Idiomas disponibles
Idiomas disponibles
Plug pack charger assembly
The plug pack charger is designed to operate on voltages
between 100Volts and 240Volts AC, 50 or 60Hz.
The only requirement is to fit the required pin insert into the
plug pack charger.
The plug pack charger consists of the charger housing and
4 clip on plug configurations.
GB
WARNING
DO NOT
attempt to use the
charger without fitting one of the
supplied clip on pin moldings.
DO NOT
insert the clip on
moldings into ANY general
power outlet without FIRST
attaching to the charger plug
pack housing.
Select the pin configuration
attachment to suit the general
power outlet to be used.
Orientate the pin attachment so
the rear of the molding aligns
with the recess in the plug pack
housing. The attachment will
only assemble one way. When
aligned, insert the pin attachment
fully and the insert "Clicks" into
place. CHECK the insert is
locked in place.
To remove the pin attachment
insert, press and slide down the
small release button and pull
the insert from the plug pack
charger.
Fitting and removing
the battery pack
To remove the battery pack from
the tool, press the two side tabs
on the battery pack firmly and
pull the pack from the tool.
To fit the battery pack into the
tool, orientate the battery pack so
the side tabs of the battery pack
are on the left and right side of
the tool, and the high trim section
of the pack is forward. Enter the
pack into the tool aligning the ribs
of the pack with the inner ribs of
the tool. Push the battery pack
all the way into the tool handle
without forcing. The side tabs will
"Click" into place preventing the
pack falling out.
To fit the battery pack into the
charger, Orientate the battery
so the side tabs of the battery
are to the sides of the charger
and the high side of the battery
trim is towards the charger base
indicators. Align the ribs of the
battery pack with the ribs of the
charger base recess and insert
the battery all the way into the
charger. The side tabs are not
used.
To remove the battery pack from
the charger base, lift the battery
from the charger base without
the need to depress the battery
pack tabs.
14
Battery charging
IMPORTANT.
Before attempting to charge the battery,
check the charger, the charger base and the battery
to ensure the charging equipment matches the battery
supplied. The components are all labelled with
component numbers.
CAUTION!
The rechargeable battery is not fully charged on
leaving the factory. Charge the rechargeable battery before
first use.
CAUTION!
The working temperature of the charger is 0
degree to 45 degrees (32 degree f to 115 degree f).
CAUTION!
When recharging the battery, connect the plug
pack charger into the charger base, then connect the plug
pack charger to the power source. The battery should be
inserted last.
1. Assemble the plug pack charger with the required pin
configuration. Connect the plug pack charger to the
charger base, and then plug in the plug pack charger into
the mains supply and turn on. The green LED will display.
2. Insert the rechargeable battery into the charger base.
The red LED will light and the same time the green one
will turn off.
3. The charging process will last approx. 45 - 60 min and
be displayed by red permanent lighting of the LED. The
charge will be completed when the red LED goes out and
the green LED lights up.
CAUTION!
If the red or green LED keeps flashing during
the charging process for more than 20 minutes, please
remove the battery and allow to cool down for 15 - 30
minutes. Then insert it into charger base again, if the LED
still flashes, the battery and charger require service.
Note. If the battery pack is still hot to hold, allow to cool for a
30 min and re insert. The charger will not charge a hot battery.
15
GB
Publicidad
