Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
13
Installing the shower head
□
Attach the shower head (C) to the shower arm (B).
Hand-tighten only.
NOTE: Do not use the thread sealant tape and do not use
wrench to tighten shower head. If the screen filter (1) in
the spray head (C) is blocked, turn off the water supply at
angle valve and unscrew the spray head (C) from spray
arm (B). Clean the screen filter (1) in the spray head (C)
under running water with brush (2, not included).
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
NOTE: Refer to the Service Parts section in this manual
for a detailed drawing showing the location of the parts
listed below.
Problem
There is no hot water.
There is no flow or a low
water flow.
Possible Cause
□
The lines are reversed or the cartridge
is installed upside down.
□
The balance valve in cartridge is
clogged with debris.
Products are in compliance with EPA's
WaterSense Specification for Showerheads,
so the maximum flow rate value should be
below 1.8 gpm. Or consider the causes
below:
□
One or both water supplies are not
turned on.
□
The stop valves are turned off or not
fully turned on.
□
The screen filter in the spray head
is blocked.
B
C
□
□
□
□
□
14
1
C
Solution
Rotate the cartridge 180°.
Clean the bottom of the cartridge.
Turn both water supply valves
to the on position.
Make sure both stop valves are
fully open. Use flathead
screwdriver to unscrew the valve
rod in the stop valve in a
counterclockwise direction until
the valve rod can't be rotated.
Turn off the water supply at
angle valve and unscrew the
spray head from spray hose.
Clean the screen filter in the
spray head under running water.
Refer to the step 13.
2
Publicidad
