ZIGOR ZGR SOLAR STR 250 Manual De Operación página 76

ZGR SOLAR STR 250
4) Strip the protection layer and insulation layer by specific length, as described in the figure below (Fig.
4-31).
5) Make the cable and crimp terminal (Fig. 4-32).
6) Secure the wires to corresponding terminals (Fig. 4-33).
NOTICE
Note the terminal positions of PE wire and N wire. If a phase wire is connected to the PE terminal or N terminal,
unrecoverable damage may be caused to the inverter.
Operation manual
Fig. 4-30 AC waterproof connector
Fig. 4-31 Strip the protection layer
Fig. 4-32 Cable and crimp
www.zigor.com 27