Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2.2 The operation process of the machine
Before start
-Under normal operating conditions of the machine, verify that no doors or lids have been
opened and that the hopper is properly closed. If the machine cannot be used after shipping,
please check each part first.
Power display
-Insert the starter key in the steering wheel console and turn
the starter switch clockwise to the "ON" position. After three
seconds, the display shows the battery voltage value. If the
voltage is lower than 42V, please charge it before use
Start the machine
-sitting in the driver's seat
-Gently depress the brake pedal and turn the starter key to the
"ON" position;
- Move the machine to the work area with the steering wheel and
the forward/reverse buttons (forward for forward, backward for
reverse). The driving speed is adjusted from 0 to the maximum
value by the pressure of the accelerator pedal;
-Press the sweep function button to start sweeping, and use
the steering wheel, accelerator pedal and forward/reverse
buttons to move the machine.
-The dustbin must be closed when sweeping.
-This sweeper implements automatic and one-button operation. When the sweeping function
button is pressed, all sweeping motors (including the main brush motor, side brush motor, and fan
motor) will automatically work, and the main brush and side brush will automatically descend.
Stop of the machine
-Release the accelerator pedal to stop the machine.
-Press the sweeping stop button. All sweeping functions are stopped, and the main brush and side
brush are raised.
-Turn the start switch to the "OFF" position
3.3 Machine Operation Precautions
-Avoid stopping the machine for extended periods of time and letting the brush roll in the same
place; this will leave unnecessary marks on the ground.
-If you need to collect large light waste, you can lift the front cover by stepping on the pedal to pass
the large light waste through the machine, remember that when
the front cover is raised, the
vacuuming capacity of the machine will be reduced.
-In order to clean the machine well, be sure to clean the filter screen, stop the machine, press the
dust vibration switch, and start the dust vibration motor to vibrate the filter within 1 minute. After
cleaning the filter, restart the sweeping operation.
-When working, the filter needs to be vibrated every 30 minutes on average. (depending on the
garbage in the area to be cleaned)
-When the filter is clogged or the bin is full, the machine cannot collect garbage and should not
work on wet ground to avoid damage to the filter.
-The bin must be emptied every time work is completed or the bin is full.
7
Publicidad
