Preliminary Recommendations - WEG CFW300 Manual Del Usuario

Ocultar thumbs Ver también para CFW300:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety Instructions

1.3 PRELIMINARY RECOMMENDATIONS

DANGER!
Always disconnect the main power supply before touching any electrical
component associated to the inverter. Several components can remain charged
with high voltages or remain in movement (fans) even after the AC power is
disconnected or switched off.
Wait at least ten minutes after turning off the input power for the complete
discharge of the power capacitors.
Always connect the grounding point of the inverter to the protection earth (PE).
DANGER!
Débranchez toujours l'alimentation principale avant d'entrer en contact avec un
appareil électrique associé au variateur. Plusieurs composants peuvent rester
chargés à un potentiel électrique élevé et/ou être en mouvement (ventilateurs),
même après la déconnexion ou la coupure de l'alimentation en courant
alternatif. Attendez au moins 10 minutes que les condensateurs se déchargent
complètement. Toujours connecter le point de mise à la terre du variateur sur la
mise à la terre de protection.
DANGER!
The XC10 connector is not USB compatible, therefore, it cannot be connected
to USB ports.
This connector only serves as the interface between the CFW300 frequency
inverter and its accessories.
DANGER!
La XC10 n'est pas compatible USB, par conséquent, il ne peut pas être connectés
à des ports USB. Ce connecteur sert uniquement d'interface entre le CFW300
variateur de fréquence et de ses accessoires.
NOTES!
Frequency Inverter may interfere with other electronic equipment. In order to
reduce these effects, take the precautions recommended in the
INSTALLATION AND CONNECTION on page 12.
Read the user's manual completely before installing or operating the inverter.
Do not perform any withstand voltage test (hi-pot test)!
ATTENTION!
Electronic boards have components sensitive to electrostatic discharges.
Do not touch directly on components or connectors.
If necessary, first touch the grounding point of the inverter, which must be
connected to the protection earth (PE) or use a proper grounding strap.
2 | CFW300
If necessary, contact WEG.
Chapter 3

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido