Descargar Imprimir esta página

MZ electronic NAUTI412 Guia De Inicio Rapido página 3

Radiocomando 2 comandos

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

TECHNICAL FEATURES
ITS USE IS ONLY ON DIRECT
CURRENT.
MUST BE USED WITH
CONTACTORS OR A CONTROL
BOX.
Feeding tension of receiver : from 9
to 30 VCC
Frequency: 433,92 Mhz or 868,35
Mhz.
Maximum load: 2 A.
Ergonomic transmitter moulded in
self-extinguishing polyester resin.
Watertight protection:
NAUTI412
IP 56 :
NAUTI422
IP 40 :
Transmitter's dimensions:
NAUTI412
: 140x60x20 mm.
NAUTI422
: 75x43x19 mm .
Receiver's dimensions:
NAUTI412
140x60x75 mm. :
NAUTI422
With ON button with late to avoid
accidental operation.
(*not available in NAUTI422)
INSTALLATION
SWITCH OFF THE BATTERY
BEFORE INSTALL THE RADIO
CONTROL!
If possible, mount the receiver a long
way the big metal masses or electric
motor of windlass.
For the electric connections, see the
wiring diagram.
Insert a fuse of 3 A on the cable to
the positive pole of the battery.
Separate
the
radio
alimentation and windlass alimentation
for the drop in voltage of these.
After connection, check that all work
properly.
CHECKING AND USE
DON'T OPEN THE RECEIVER TO
WARRANTY WATERTIGHT
PROTECTION!
1. In the NAUTI422, the command are
always ready for use.
2. Push button ON for 2 seconds. A
red led switch on blinking on the
transmitter.
3. Push the button UP to haul the
anchor and button DOWN to weigh it.
During the operation, the red led is
fixed.
4. Release the button to stop the
manoeuvre. Red led is blinking.
5.
The transmitter switch off about
90 seconds after the last command is
given. Repeat from point 2 to repeat
operation.
DON'T PUSH THE BOTTON
SIMULTANEOUSLY!
The transmitter MAXI is supply WITH
control
BATTERY.
BE SURE TO FIX THE SCREWS TO
WARRANTY WATERTIGHT
PROTECTION OF TRANSMITTER!
For the other substitution, use only
alkaline battery of 12Volt, type E23A
(9V type MN1604 for NAUTI412).
3

Publicidad

loading

Este manual también es adecuado para:

Nauti422