Haier JG45B Manual De Instrucciones página 10

 Setting The Temperature Controls
• When pressing "
compartment automatically. The LED will flashing and display the setting temperature.
Press once the button, the temperature will decrease or increase 1 ℃. When exceeding the minimum value that
can be established, it will jump to the highest adjustable temperature value automatically. After stopping pressing
the button for 5 seconds, LED figure will stop flash, then revert back to display the temperature of the upper or
lower compartment.
After the unit is unplugged, the system will return to acquiescence temperature, which setting by factory. The

acquiescence temperature as below:
Upper compartment: 6 ℃
Lower compartment: 12 ℃
If want reveal every indoor setting temperature, please corresponding to press " Set Upper " or " Set Lower "

button, the LED will flash and display the setting temperature. After stopping pressing the button for 5 seconds,
LED figure will stop flash, then revert back to display the actual temperature.
Upper compartment: The temperature setting can be adjusted from 5℃ to 10℃.
Lower compartment: The temperature setting can be adjusted from 10℃ to 18℃.
 Temperature Alarm
If the temperature inside is higher than 23
will sound. This indicates that the temperature inside is too high. If the temperature inside is lower than 0
on the display panel and at the same time the alarm also malfunction indicator is active.
 Temperature Recollection Function
In the event of a power interruption, wine chiller can remember the previous temperature settings, and when the power
is recovery, the cooler temperature will go back the same setting temperature as power off.
 Overtime Open the Door Alarm
When you forget close the door or the door is not closed completely, the buzzer alarm after 5 minutes. Please close the
door completely and avoid the cold energy was lost.
 Internal light
In order to reduce energy consumption, the LED light within this wine cabinet will automatically switch off when
closed the door. If you would prefer the LED light to remain on continuously, this is possible. Please press and hold
the "LIGHT" bottom for 5 seconds, the display will show "LP". After 4 seconds the display will revert back to normal
and the light will remain on until manually switched off.
If you would like to revert back and conserve energy (recommended), press and hold the "LIGHT" button for 5
seconds, the display will show "LF". After 4 seconds the display will revert back to normal
the light will be on when door open and the light turn off when door closed.
" or " " button, the system will be entering the set up mode in the upper or lower
℃
, it will display "HI" on the display panel, and after one hour after the alarm / buzzer
8
℃
, it will display "LO"
EN