Haier JG45B Manual De Instrucciones página 7

 Installing the handle
 Screw
 Screw covers (attached to manual bag)
 Handle
 Door
Fig 1
CAUTION:
Do not over-tighten the screws as this may cause damage to the handle or to the door.
1. Open the door and carefully pull out the door gasket
only at the area where the handle is to be installed.
2. You will be able to see two screws inside the door.
3. Insert the screw cover in the arrow direction (only for
full glass door and slim stainless-steel door). see Fig
1
4. Drive the upper screw for 3 or 4 circles, and then
drive the lower screw for 3 or 4 circles for align the
handle
5. Alternatively tighten the upper and lower screw
until the handle is flush against the door frame.
6. Carefully press the door gasket into its original
position.
1
4
5
2
3
4
EN