Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
2
(2) Remove the installation material
4
5
(5) Latch the 2 locking hooks of the front cover onto the locking webs of
the housing.
(6) Fold the front cover onto the housing.
(7) Latch in the cover audibly with a light pressure
Siemens Building Technologies
4
(4) Drill the four holes, each 170 mm apart
You should use at least 2, better 4 fixing points to fix the WTT563..
securely on the wall.
6
Install the device out of reach at a minimum installation height of
200 cm.
The following tools are necessary for correct installation:
• Slot-head screwdriver for simple opening of the housing cover
• Cross-head screwdriver or cordless screwdriver
• 5 mm stone drill bit for drilling the plug holes (5 mm) in the wall
1
(1) Remove the front cover of the housing by:
•
Inserting the screwdriver in the right-hand slot and
pushing downwards to lever the cover open
•
Inserting the screwdriver in the left-hand slot and
pushing downwards to lever the cover open
3
When drilling ensure you do not damage any utility pipes or cables
(electricity, water, IT network, etc) laid in the wall.
7
2017-08-28
(3) Connect the two
battery cables to
one another.
8
(8) Seal the enclosed anti-tamper seal of
the gateway.
A6V10897697_----_b
EN
33
Publicidad
