Maintenance; General Maintenance; Spool Replacement - McCulloch Li 40T Manual De Instrucciones

General maintenance

WARNING! When servicing, use only
!
identical replacement parts. Use of any
other parts may create a hazard or cause
product damage.
WARNING! To avoid serious personal
!
injury, always remove the battery
pack from the tool when cleaning or
performing any maintenance.
Before each use, inspect the entire product for
damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Securely tighten all fasteners and
caps and do not operate this product until all missing or
damaged parts are replaced.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease,
etc..
WARNING! Do not at any time let
!
brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in
contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which
may result in serious personal injury.
Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an Authorised Service Centre.

Spool replacement

Use original manufacturer's replacement cutting line for
best performance.
• Remove the battery pack.
• Push in tabs on sides of spool cover.
12 - English

MAINTENANCE

Tab
• Pull spool cover up to remove.
• Remove the old spool.
• To install the new spool, make sure the cutting line
is captured in the slot on the new spool. Make sure
the end of the cutting line is extended approximately
15cm beyond the slot.
Cover
Spool