Batavia MAXXPACK BT-CB001 Manual De Usuario página 10

Use
b. Adjust the position of the attachment
clip (12) and the tilt of the extra handle (4)
to your needs and tighten the locking
screw again.
Working with the device
6.5.
a. For wet use, close the stopcock and
connect the hose adapter to your water
supply. Adjust the water quantity with the
stopcock (see Fig. A).
b. Press the ON/OFF switch (8) to turn the
device on.
It is not necessary to hold the ON/OFF
switch during use.
Only exert minimal pressure (gentle feed
motion) on the device when working.
Gently and evenly push the device
forwards.
c. Press the ON/OFF switch again to turn the
device off.
Mounting the extension pole (optional
6.6.
accessory)
The extension pole is an optional accessory
and not delivered with the device. Do not use
more than one extension pole with the device.
a. Pull the hose adapter (11) off the guide rail
of the attachment clip (12). (see Fig. I)
b. Unscrew the grip sleeve (2) and pull the
two tube ends apart.
c. Unscrew the fitting and pull the plug (22)
and the socket (20) apart.
d. Place the motor unit (17) and the exten­
sion pole (19) with the tube ends facing
each other.
e. Slightly pull the socket (20) using the tug
strap (21) and the plug (22) out of the tube
ends. (see Fig. B)
f. Connect the socket and the plug with the
arrows pointing towards each other and
screw together tightly.
g. Connect the two tube ends (arrows
pointing towards each other) and screw
them together with the sleeve (2).
h. Place the power supply unit (5) and the
extension pole (19) with the tube ends
facing each other.
10
i. Slightly pull the socket (20) using the tug
strap (21) and the plug (22) out of the tube
ends.
j. Connect the socket and the plug with the
arrows pointing towards each other and
screw together tightly.
k. Connect the two tube ends (arrows
pointing towards each other) and screw
them together with the sleeve (2).
l. Slide the hose adapter onto the guide track
of the sleeve (23).
7. Maintenance, cleaning and storing
Keep the device and its accessories in good
and clean condition to ensure easy and safe
working.
Remove the battery pack from the tool before
carrying out any adjustment, servicing or main­
tenance.
If the bristles of the brush are
deformed by transport or incor­
rect storage, immerse the brush
in hot (90 degrees Celsius) water
for 30 seconds. The bristles of
the brush then return to the
correct shape.
8. Technical data
Battery type:
No load speed
(ø100/180 mm):
Sound pressure level L
Uncertainty K :
pA
Sound power level L
WA
Uncertainty K :
WA
Hand/arm vibration a
Uncertainty K:
Vibration level
8.1.
The declared vibration total value and the
declared noise emission values have been
measured in accordance with a standard test
method (EN 62841) and may be used for
comparing one tool with another. The declared
vibration total value may also be used in a
preliminary assessment of exposure.
18 V,
4000 mAh, Li-
Ion
200/400 min
: 66 dB(A)
pA
3 dB(A)
: 77 dB(A)
3 dB(A)
: 3.91 m/s
2
h,b
1.5 m/s
2
-1