FONESTAR PROX-240S Manual De Usuario página 2

EN
DESCRIPTION
- Distributed audio for PA installations with 100 speakers, also with low impedance output.
- Safe and durable connections with low maintenance.
- With 3 mic/line inputs and 2 auxiliary inputs.
- User-friendly operation and a modern, discreet design.
CONTROLS AND FUNCTIONS
FRONT PANEL
PA AMPLIFIER PROX-240S
1
1.- : indicator light and on/off switch of the amplifier.
2.- CH 1 - PAGING MIC/CH 2/CH 3/CH 4: volume controls for the CH 1, CH 2, CH 3 and CH 4 inputs on
the rear panel.
1
3.- MASTER: volume control of the input selected by the INPUT selector switch.
4.- INPUT: input source selector: AUX 1 o AUX 2.
PA AMPLIFIER PROX-240S
5.- SIGNAL: signal status indicator light. Lights up when signal is detected at the inputs.
6.- CLIP: signal peak indicator light for each input. If it lights up lightly or occasionally you should reduce
the output volume. If the indicator light stays on continuously, it is because the input signal is very high.
In this case, reduce the input signal volume.
7.- PROT: protection indicator light. Lights up when the temperature channel protection is activated. With
protection enabled, the audio output of that channel is cut off. If this happens, turn off the computer,
make sure that the vents for air intake and exhaust are free of obstructions and turn down the volume
1
of the input signal.. Wait a few minutes for the appliance to stabilize before you switch it on again.
REAR PANEL
1
1.- AUX 2/AUX 3: stereo auxiliary inputs for connection of audio devices such as mixers, computers, etc.
These inputs have 2 connector options, 2xRCA or euroblock.
2.- CH 2/CH 3/CH 4: audio inputs from dynamic microphone (MIC), condenser microphone (PHANTOM 48
V) or lines (LINE), balanced eurolock connector. Once the input type has been selected with the MIC/
PHANTOM 48 V/LINE selector, the gain of the input can be adjusted with the GAIN control.
2 3 4 5 6
2 3 4
CH 3
2
7 8 9 10
CH 3
2
5 6 7 8 9 10
- 2 -
CH 4
3 4
11 12
CH 4
3 4
11 12
5 6 7
5 6 7