Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
MARKER OPERATING INSTRUCTIONS
1) Opera�ng Guide
FTP TARGET SETTING:
Once power on the meter, LCD show "FTP" and the target value, 120 Wa� as factory default.
1.To press UP or DOWN key to adjust the se�ng value.
2.Press ENTER/RESET key to confirm.
EXERCISE TARGET SETTING:
Exercise Target Se�ng is the func�on as COUNTING DOWN by Time or Distance. If user doesn't set
any Exercise Target as the free-ride mode then the monitor will be counted up all exercising values.
1. Under free-ride mode, to press ENTER/RESET key for two or three �mes to set the Target
Time or Target Distance.
2. To press UP or DOWN key to adjust the se�ng values.
To press UP + DOWN keys simultaneously to clear the se�ng values.
3. The se�ng mode will be close without pressing any key for 1 minute.
4. The monitor will start to measure and display every exercise values a�er se�ng.
Once the exercise target value is reached, the monitor will beep for 3 seconds, press any key can stop
the beep. The monitor will automa�cally into the free-ride mode without any new se�ng.
DISPLAY VALUES SELECTION:
To press UP key to select display values as below changed:
SPEED
CAL (CALORIE)
RESET EXERCISE VALUES:
Press ENTER/RESET key and hold for 5 seconds to clear all exercise values and exercise target values.
METRIC / IMPERIAL SYSTEM:
Use a pen's �p or pin and push down the "k/m" bu�on on the back of the meter to switch between
imperial and metric display.
RPM
DIST (DISTANCE.)
49200 ESP-ENG V032022
Publicidad
