Publicidad
Switching ON and OFF
• Before operating the compressor, place it on a flat, level,
solid surface with good ventilation and away from
flammable objects, such as curtains, etc. Leave a space of
at least 12" (30 cm) around the compressor for air
circulation.
• Connect the plug to the power outlet. Make sure the
cord does not become an obstacle to avoid tripping over
or damaging it.
• Lift the switch (A) to turn on the compressor. The motor
will start and fill the tank to its maximum pressure, then
shut off automatically. It will start again when the pressure
switch detects the pressure drop during the use of the
compressor, to maintain the constant pressure, indicated
on the pressure gauge (B).
• To turn off the compressor, press the switch, then release
the air remaining in the tank by pulling the pressure
release valve ring (C).
CAUTION
• Never disconnect the compressor from
the power supply to turn it off. If the power supply is
accidentally cut off, do not forget to press the switch to
shut down the compressor properly.
• The compressor has a thermal switch (D) that prevents
the motor from overheating. The motor shuts off when the
switch is activated. To reset the motor, press the thermal
switch located on the side of the motor crankcase.
Operation
• Connect the end of the air hose to the compressor outlet (E).
• Connect the other end of the air hose to the inlet of the
pneumatic tool (not included). Make sure the connections
match each other.
• Adjust the air outlet pressure with the pressure regulator ( F),
turn the knob clockwise to increase the outlet pressure, turn it
counterclockwise to decrease it until the desired pressure
indicated on the outlet pressure gauge (G) is reached.
• The pressure adjustment must be made with
CAUTION
the regulated air outlet valve open.
• After connecting the compressor to the air line, run it under
load at maximum pressure and make sure it is operating
properly.
• Check for leaks in the air line. Turn off the compressor to
repair any detected leaks.
• The motor and its housing can reach high
CAUTION
temperatures. When working with the compressor avoid
touching this area to prevent burns.
8
ENGLISH
Start Up
A
C
B
G
F
E
D
Publicidad
