Wagan Tech Easy Quick Jumper II Manual De Usuario página 3

TROUBLESHOOTING
Problem:
The green "POWER" LED does not illuminate when the black DC plug in inserted
into the working vehicle.
Possible Causes:
• The plug is not fully inserted into the cigarette lighter socket.
• The engine of the operating vehicle is not running.
• The operating vehicle's DC socket has a negative center post.
• The fuse is blown.
Problem:
The green "POWER" LED illuminates, but the red "CHARGING" LED does not
illuminate in sequence.
Possible Causes:
• The red plug has not been properly inserted into the vehicle with the dead
battery.
• The ignition lock of the vehicle with the dead battery is not in the
"ACCESSORY" position.
• The vehicle with the dead battery has a negative center post in the DC
socket.
• The fuse is blown.
Problem:
The vehicle with the dead battery will not start after 25 minutes.
Possible Causes:
• The battery is fully discharged or shortened internally.
• Plugs are not properly inserted in DC sockets.
• The fuse is blown.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2014 Wagan Corporation. All Rights Reserved.
3