FUXTEC FX-MT152 Manual De Instrucciones página 103

Original Bedienungsanleitung FUXTEC FX-MT152/-MT152E/-MT252_de_en_fr_ita_es_rev20
2. Difficulties during operation
Situation Cause
Choke is in "COLD START" position, an
The engine does exhaust system is blocked no air supply,
not reach the moving elements worn, ignition spark
speed weak too large valve clearance, cylinder
head sooty
Operating
Lines to carburetor blocked Spark plug
materials are
spacing incorrect
leaking
Engine- Wrong choke position,
Noises Camshaft damaged
Failure of the check valve on the tank cap
Carburetor
leaking
Carburetor gasket is worn out
If no troubleshooting solves the problem, contact your dealer or the
manufacturer directly. Only use original parts approved by the manufacturer.
Otherwise, there is a risk of danger.
INFO: Optional accessories (adjustable pole saw)
Assembly: Pull the knob back and position the desired angle on the attachment and
release the knob so that the pin can engage in one of the holes.
Open choke, replace exhaust system
Check or replace ignition coil, adjust
flywheel, spark plug
Replace the lines and, if necessary,
the carburetor; adjust gap dimension
Check/replace camshaft
Replace the fuel filler cap
Replace carburetor or gasket
103
Solution