Batavia Maxxspray BT-CPS002 Manual De Usuario página 11

Proper spraying technique
7.7
• If spraying with an HVLP spray system is
new or unfamiliar to you, it is advisable to
practice on a piece of scrap wood or
cardboard before beginning on your
intended work piece.
a. Preparing the surface
• Carefully cover a large area around the
spray surface. Any surface that is not
masked could become contaminated.
• Ensure that the surface is clean, dry and
free of grease.
• Polished surfaces should be lightly
sanded and the sanding dust removed.
b. How to spray properly
(See Fig. E, F).
• Hold the spray gun at a constant dis-
tance from the object. The ideal spraying
distance is approx. 15 cm.
• Spray evenly up and down with smooth
passes at a consistent speed as illus-
trated in fig. E. Doing this will help avoid
irregularities in the finish (i. e. runs and
sags).
• Always apply a thin coat of material on
the first pass and allow to dry before
applying a second, slightly heavier coat.
• The closer your sprayer is to the object
being sprayed the more the over-spray.
• When spraying, always press and hold
the trigger of the spray gun after spray
pass has begun and release trigger
before stopping the pass. Always keep
the gun pointed squarely at the spray
surface and overlap passes slightly to
obtain the most consistent and profes-
sional finish possible.
Switching the spray gun on/off
7.8
a. Switching on
To switch the spray gun on, press and hold
the trigger (6).
b. Switching off
To stop spraying, simply release the trigger (6).
8. Cleaning the spray gun
(See Fig. G, H).
Special clean-up instructions for
use with flammable solvents (must
have a flash point above 21 °C):
• Always flush spray gun outside.
• Area must be free of flammable vapours.
• Cleaning area must be well-ventilated.
• DO NOT SUBMERGE air compressor!
Ensure the battery has been removed
8.1
from the appliance.
Push the fixing clip (8) down.
8.2
Hold the spray attachment (16) and
8.3
turn the blower unit (24) 90°
counter-clockwise.
Remove the blower unit from the spray-
8.4
ing attachment.
Unscrew the material tank (10) from the
8.5
spray attachment by turning it
clockwise.
Discharge the residue in the material
8.6
tank into a suitable storage container or
dispose of it properly.
Fill the material tank with solvent or
8.7
water.
Screw the material tank onto the spray
8.8
attachment by turning it
counter-clockwise.
Replace the battery in the battery
8.9
holder.
Pull the trigger guard (6) and spray
8.10
solvent or water into a container or
cloth for 2-5 seconds.
Repeat this process until clear solvent
8.11
or water only comes out.
Unscrew the material tank (10) from the
8.12
spray attachment by turning it
clockwise.
Pull the trigger guard for approx. 2 sec-
8.13
onds to empty the system.
Remove the battery.
8.14
Drain the material tank completely.
8.15
Remove the suction tube (18) from the
8.16
spray attachment.
Pull out the valve (17). Gently unscrew it
8.17
and clean off any dirt.
Clean the exterior of all parts of the
8.18
appliance with a cloth soaked in solvent
or water.
Unscrew the union nut (1) from the
8.19
spray attachment by turning it
counter-clockwise.
English
9