Manuales relacionados para Truper PRO LIRO-5A
Resumen de contenidos para Truper PRO LIRO-5A
- Página 1 Manual Random 0.34 Hp 5” orbit sander Power Sanding disc Applies for: Code Model 15398 LIRO-5A LIRO-5A Read the user’s manual thoroughly CAUTION before operating this tool.
- Página 2 Contents CAUTION Technical data Power requirements To gain the best performance of the tool, prolong the duty life, General power tool safety warnings make the Warranty valid if necessary, and to avoid hazards Safety warnings for orbit sanders of fatal injuries please read and understand this Manual before Parts using the tool.
- Página 3 Technical data LIRO-5A Code 15398 Description Random orbit sander Base 5” Voltage 127 V~ Frequency 60 Hz Current Power 0.34 Hp Speed 13 000 OPM Dust collection Duty cycle 30 minutes work per 15 minutes idle. Maximum 3 hours per day. Conductors 18 AWG x 2C with insulating temperature of 221 °F Insulation...
- Página 4 General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
- Página 5 Safety warnings for orbit sanders CAUTION WARNING • Observe the applicable regulations • Remove the dust bag before when sanding painted surfaces. Use special care when the sanding metal. Sparks may ignite dust and the inner paint is lead-based. pouch. •...
- Página 6 Preparation Sanding Disc Selection Grain Type 60 or lower very coarse • Grains available vary from very coarse to very fine. 80 - 100 coarse • Coarse grain is used to sand rough surfaces, medium grain, 120 - 150 medium for light work and fine grain is for smooth finish.
- Página 7 Start up Switch On • Connect the plug into the power outlet. • To start the tool, press switch (C) into the ON position ( I ). • To shut off the tool, press the switch to the opposite side. Do not start the tool when the sander surface is onto CAUTION the work piece.
- Página 8 Maintenance Cleaning and Care Always keep the ventilation slots in the motor housing clean and free of obstructions. After each use apply compressed air. In the event of malfunctioning go only to a Authorized Service Center. Carbon Brush Replacement • Carbon brushes need to be checked regularly and when worn, replaced in a Authorized Service Center.
- Página 9 Authorized service centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800-018-7873 to get information about the nearest Service Center.
- Página 10 It includes the costs of transportation of the product that derive from its fulfillment of its service network. . Phone number 800-018-7873. Made in China. Imported by Truper, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257, Phone number 761 782 9100.