Descargar Imprimir esta página

MSW Motor Technics S-CHARGER-6V12-10A Manual De Instrucciones página 24

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 73
The device sounds an
alarm.
The battery is not
providing power or is
too weak, but the
"Full" indicator on
the control panel
lights up when
charging.
After connecting the
clamps to the
battery, the display
shows the current
battery voltage, but
after connecting the
plug to the power
outlet, nothing
changes - the battery
is not charged.
Despite the long
charging time, the
battery is still not
fully charged (the
"Full" indicator on
the control panel of
the device does not
light up) or the
battery becomes very
hot.
Inversely connected
terminals to the poles
(confused with "+"
with "-").
Defective battery; Too
low electrolyte level,
leaking battery
housing. The internal
resistance of the
battery is too high or
has a reduced capacity.
No power in the 230V
socket.
The problem with the
battery, i.e. leakage,
loss of electrolyte.
ATTENTION:
overheating the
battery leads to its
damage and may cause
an explosion!
connection of the
terminals to the
poles.
Change the
connection of the
clamps to the poles.
If that doesn't help,
the battery is most
likely defective.
Try to charge the
battery in the
battery regeneration
mode - if a few
attempts do not
work despite the
"Full" indicator
being lit, the battery
must be replaced.
Try to insert the plug
of the device into a
different outlet to
check if it is the fault
of a specific outlet
or a general lack of
power in the 230V
installation.
Switch off charging
immediately and
allow the battery to
cool down. Then
check the battery
carefully for leakage
and loss of
electrolyte. If the
battery is leaking,
replace it with a new
one, and if there is
too little electrolyte,
refill it to the
maximum allowable
level.

Publicidad

loading

Este manual también es adecuado para:

S-charger-12v24-10aS-charger-12v24-14aS-charger-12v24-25a