Publicidad
Idiomas disponibles
Idiomas disponibles
The nailer will recoil after the fastener is
driven into the work surface . Use sufficient
grip to maintain control and alignment of the
nailer with the work surface during firing and
recoil .
7 . Release the Trigger 2 and pull the nailer
away from the work surface .
To avoid accidents, always disconnect the Battery Pack from the tool before
cleaning or performing any maintenance .
Do not point the tool towards yourself or anyone nearby . Unexpected triggering
will discharge the fastener causing an injury .
General Maintenance
Keep your nailer, battery pack and charger in
good working order by adopting a regular main-
tenance program . Inspect your nailer for issues
such as undue noise, misalignment or binding
of moving parts, breakage of parts, or any other
condition that may affect the nailer operation .
This nailer does not contain user-serviceable
parts . The gas reservoir should be recharged
only by an authorized service provider .
It is recommended after 6 months to a year,
depending on use, to return the nailer, battery
pack and charger to a BOSCH service facility for
inspection .
If the nailer does not start or operate at full
power with a fully charged battery pack, clean
the contacts on the battery pack . If the nailer
still does not work properly, return the nailer,
charger and battery pack, to a BOSCH service
facility for repairs .
Service
NO
PARTS INSIDE . Maintenance
performed by un au thorized personnel may re-
sult in misplacing of internal wires and compo-
nents which could cause serious hazard . We
recom mend that all tool service be performed
by a Bosch Factory Service Center or Authorized
Bosch Service location .
1605A001CD GNB18V-12 202301.indd 23
Operation
Maintenance
USER
SERVICEABLE
To fire another fastener the Trigger and
Nosepiece must be released and the firing
sequence, steps 5 -7, repeated .
Note: The nailer will switch off after 30 minutes
of inactivity .
Cleaning
Clean dust and debris from any vents and fast-
ner magazines . Keep nailer clean, dry and free
of oil or grease . Use only mild soap and a damp
cloth to clean housing, since certain cleaning
agents and solvents are harmful to plastics and
other insulated parts . Some of these include
gasoline, turpentine, lacquer thinner, paint thin-
ner, chlorinated cleaning solvents, ammonia
and household detergents containing ammonia .
Never use flammable or combustible solvents
around tools .
Remove collation plastic and clean accumulated
dust from the magazine to allow the fasteners to
feed smoothly .
Repairs
For repairs, return the nailer, battery pack and
charger to the nearest Bosch service center, or
Authorized Bosch Service location .
23
1/9/23 2:07 PM
Publicidad
