Publicidad
Idiomas disponibles
Idiomas disponibles
English
W ........................ watts
or AC ........... alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.
Intended Use
This pressure washer is intended for cleaning boats, cars,
decks, driveways, grills, house siding, motorcycles, patios,
and outdoor furniture.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Specifications
Maximum Pounds per Square Inch
Rated Gallons per Minute*
Electrical Requirements
Electrical Cord
High Pressure Hose
Minimum Amp Source
Pressure of Inlet Water*
Inlet Water
Soap Consumption Rate
*Water flow and maximum pressure ratings determined in accordance with
CETA CPC-100.
4
..................... avoid staring at
light
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
IPXX .................... IP symbol
1,800
1.2
120V
~60Hz, 13A
AC
35 ft. (10.6 m)
20 ft. (6.1 m)
15A
20-100 PSI
Cold Tap
10% MAX
Attaching Spray Wand (Fig. B)
To connect the spray wand
the end of the spray wand inside the spray handle and turn
the spray wand counterclockwise to lock it into position.
Fig. B
Attaching High Pressure Hose (Fig. C, D)
NOTICE: Never pull high pressure hose to move pressure
washer. This could damage hose and/or pump outlet.
To connect the high pressure hose
handle
4
, screw the hose collar
inlet coupler
16
.
To connect the high pressure hose to the pressure washer
unit
8
, screw the hose collar
water outlet
17
.
Fig. C
Attaching Garden Hose (Fig. A, D)
To connect a garden hose to the pressure washer unit
place the end of the garden hose inside the water
intake
18
. Tighten the garden hose by hand.
Always disconnect the garden hose after usage.
nOTE: Before connecting the garden hose to the pressure
washer unit, run water through the garden hose for thirty
seconds to clear any debris from the mouth of the garden hose.
Fig. D
2
to the spray handle
4
, insert
4
1
to the spray
15
onto the spray handle
14
onto the high pressure
4
8
2
16
15
1
8
,
17
18
Publicidad
