MESTIC MCCP 35 Instrucciones De Uso página 10

Dual Zone only:
• The temperature shown on the left display, corresponds to the larger left cooling compartment. The temperature
shown on the right display corresponds to the right cooling compartment.
• Setting Celsius/Fahrenheit: press the
(positioned at right side of control panel) at the same time to select Celsius or
Fahrenheit.
• Battery protection: press, hold and release
desired setting.
Battery power detection
The device features a multi-level battery guard that protects your vehicle battery from excessive discharge when the
device is connected to the built-in DC power supply. If the cooler is operated with the vehicle ignition off, the cooler
will shut off automatically when the power supply voltage drops below a set level. The cooler will turn back on once
the battery is charged to the restart voltage level. The compressor will restart automatically in a few minutes when the
voltage returns to normal values.
2. Method for adjusting the battery protection:
Protection
Cut off Voltage
Low
Middle
High
Cleaning
• Before cleaning, remove the products from the device and remove the plug from the power supply. Only clean with a
slightly damp cloth, if necessary a non-aggressive cleaning agent can be used. After cleaning, always dry all wet surfaces
with a dry cloth.
• Never use sharp or abrasive products to clean the device.
• Defrost the cool box: frost can settle on the evaporator or inside of the cool box due to humidity, this can reduce the
cooling capacity. The cool box must be defrosted in time. As follows
• Take the products out of the cool box
• Switch off the device
• Open the lid
• Sweep up the melt water or drain the melt water through the plug.
and
12V
Cut in Voltage
9.6V 10.9V
10.4V 11.7V
11.1V 12.4V
button
button to select the
Cut off Voltage
21.3V
22.8V
24.3V
24V
Cut in Voltage
22.7V
24.2V
25.7V