MESTIC MCCP 35 Instrucciones De Uso página 9

• Only use the DC 12V or 230V connection cable (not included).
• Defrost the device regularly to ensure that the device functions optimally.
• Note: do not use any electrical device to defrost the cool box.
• Do not pull on the connecting cord, but pull on the plug to remove the cord from the socket.
• If the cool box is connected to the DC socket, disconnect your cool box and other consumers from the battery before
you connect a fast charger
• If the cool box is connected to the DC socket; switch off the cool box or break the connection when you switch off the
engine. The battery can be discharged otherwise.
• Pay attention! That the heat that arises during the operation of the cool box can be properly dissipated.
• Enough distance between product and objects and walls.
• Never immerse the device in water
• Ventilation slots are not covered at all times.
Use
• Remove all packaging materials from the device.
• Place the device on a flat and stable surface with at least 10 cm of free space on each side.
• Do not switch the appliance on immediately after you transport it, where the cool box has been tilted more than -30°.
This could cause damage to the cooling system. The device must first stand upright for 24 hours so that the coolant can
be collected again in the compressor. This prevents the compressor from running dry.
• Look at the above user conditions before use.
• For hygienic reasons, you must clean the inside and outside of the appliance with a damp cloth before using your cool
box. (see paragraph
• Connect the cooler box.
AC and DC connection
• The unit is equipped with an electronic control system that will prevent polarity reversal. In the event that the battery
polarity is reversed, the unit will not start or operate. The power inlet socket is fitted with a 15A fuse for protection.
Plug the 12/24V connection cable into the DC voltage socket and then connect it to the cigarette lighter or a suitable
12V or 24V power source.
• The unit is equipped with a multi-voltage power supply with a priority circuit for connecting to an AC voltage source
of 230V. The power supply automatically switches to mains power when the device is connected to 230V AC, even if the
12/24V connection cable is still plugged in. The power inlet socket is fitted with a fuse for protection. Plug the 230V
connection cable into the AC voltage socket and connect to a suitable 230V AC power source.
Note: The USB connector only works when the cool box is being charged through the DC power cord.
Control
• Switching on and off: press and hold the on / off button, the refrigerator will now start or switches off
• Fast cooling / energy saving mode: press the set button to quickly switch between cooling mode MAX and
energy saving mode ECO. Green is Eco and blue is MAX
• Temperature adjustment: press the or button to adjust the temperature, The temperature is
now set.