Changing The Cutting Attachment Position (Central/Side) - Dolmar PC-7612V Instrucciones De Manejo Originales

Mounting direction
A
Belt cover
End of screw
Plier
Arm
Relocate
Bolts
Grip
Fig. 5
B
Fig. 1
Tension adjustment screw
Hex. nuts
Hood
Fig. 2
V-belt
Fig. 3
Lock shaft
Fig. 4
Grip
V-belt
Pulley
Changing the cutting attachment position
(central/side)
Mounting direction of hood
• The Power Cutter's cutting attachment is mounted in the
direction shown in Fig. A. If desired, use the following procedure
to mount it in the direction shown in Fig. B.
Mounting in direction B
(1) Loosen tightening nut, and turn tension adjustment screw to
the left until the end of the screw is visible. (Fig. 1)
(2) Remove tightening nuts and remove belt cover. (Fig. 1)
(3) Rotate the hood to the broken line position. Remove V-belt
and then remove cutting attachment from the Power Cutter.
Reposition the grip. (Fig. 2)
(4) Pick up the lock shaft with a slotted screwdriver or a plier.
(Fig. 3)
(5) Rotate the arm until it contacts the grip and return the lock
shaft to the original position by hand. (Fig. 4)
Reposition the grip. (Fig. 5)
(6) Turn over the removed cutting attachment, pass bolt through
hole, and remount in direction B.
Remount the V-belt to the pulley. (Fig. 6)
(7) Mount belt cover. (Fig. 7)
Turn the tension adjustment screw to adjust the tension of the
V-belt. Once tension adjustment is finished, firmly tighten the
tightening nut.
Holes
Belt cover
Bolts
Fig. 6
22
Belt cover
Hex. nut
Fig. 7