LaserTrack LT445 Manual De Instrucciones página 10

Programming the Target Lasertrack
1. Park your vehicle at a few meters distance and in line with the basic transponder. Make sure that the
LT400 is in stand-by mode.
2. Press the BUTTON-1 or BUTTON-2 button (depending on the group it is connected to) on the
control circuit board for 2 seconds.
Result: The corresponding LED blinks. LED 10 shall blink for 10 seconds and it will subsequently start
fl ashing when the code from the LT400 is received. The code of the vehicle is saved in the memory.
OR
Result: The corresponding led blinks repeatedly for 30 seconds after which it returns to the usual
fl ashing pattern. This means that the code of the vehicle has not been received. Check the position of
the vehicle and the basic transponder and repeat the procedure from step 2 onwards.
A maximum of 50 vehicles can be programmed into the system in the above manner. Program the
second transponder in manner described above if you have connected two LT420 transponders to a
single control circuit board.
Important: The car transponder concerned has to be reset after programming the LT400 car transponder.
The LT400 switches off after a programming cycle to prevent the gate or garage door to be opened
immediately.
Deleting vehicles from the basic system memory
All the codes saved in the memory of the connected transponder shall be deleted if you press BUTTON-
1 or BUTTON-2 for more than 5 seconds. The LED shall blink 5 times to confi rm it.
The vehicles that should have access should be programmed into the memory again. All codes are
retained in the event of a loss of power.
12