Safety Device; Water Supply - Lavorwash Metis Manual De Instrucciones

EN
people, animals or things deriving from the non-
compliance with the following instructions.
• K6
Check that both the machine and its com-
ponents are undamaged when unpacking them.
Contact your reseller in case of doubts.
• K7
Make sure that the rating corresponds to
the factory power line before energising the ma-
chine.
• K8
De-energise the machine before any cle-
aning or maintenance activity.
• K9
Never leave the machine energised if
unused. Turn the main switch off.
• K10De-energise the machine in case of failure
and / or troubles. Do not tamper with its controls
and equipment. Just contact the authorised after-
sales service points for servicing purposes and al-
ways order original spare parts.
• K11
The draining and loading pipes, the sa-
fety sheaths and the solenoid valves must not be
cut and tampered with. De-energise the machine
in case of damages
• K12
Any use of the machine other than the
one it has been built for represents an anomalous
condition and can cause serious damages to the
operating means and entail a serious risk for the
operator using it.
• K13
Never remove or hide the warning labels
applied to the machine.
• K14
The same instructions are valid for va-
rious models; some details may differ according
to the machine model.
• K15
Never touch or start the machine with
wet hands or bare feet;
• K16
Remove the casings and the doors of the
electric boards only once the machine has been
stopped and de-energised;
For fire-prevention purposes:
• K18
Keep all inflammable or combustible pro-
ducts away from the equipment area.
• K19
Obviously, the above-mentioned instruc-
tions are not sufficient to prevent all sorts of acci-
dents; therefore, the user will have to be cautious.
• K20 The machine must not be modified or chan-
ged in any way without the builder's written au-
thorisation.
• WARNING: We recommend the use of demine-
ralized water.
• WARNING: Never use the power cable or the
gun cable to move it.
> SAFETY DEVICE
• WARNING: the gun is fitted with a safety
catch. Whenever use of the machine is
interrupted it is important to operate the
safety catch to prevent accidental activation
of the jet.
Safety features:
- Safety valve
- Manostat
- Thermostat
- Pump with a by-pass valve or stopping device.
> STABILITY
• WARNING:
The machine must be always kept
on horizontal bases, in a safe and stable way.
> WATER SUPPLY
Water supply collection
Water supply from the water main
- Connect a supply hose (not included) to
the water inlet of the unit and to the water
supply.
- Open the water supply.
WARNING: (symbol) machine not
suitable for connection to the potable water
mains.
The cleaner can only be connected to the wa-
ter mains if the water mains is separated by a
backflow preventer. Make sure that the hose
is at least Ø 13mm-1/2 inch and that it is rein-
forced.
• WARNING: Water that has flown through
backflow preventers is considered to be
nonpotable.
IMPORTANT: Only clean or filtered water
should be used for intake. The delivery of
the water intake tap should be equal to the
double of the maximum pump range.
- Maximum intake water temperature: 40°C
- Max inlet water pressure: 1Mpa
Place the machine as close to the water supply
system as possible.
14