Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Batteries
1. Insert the batteries (12) on the groove and slip them
all the way until you hear a "click" noise from the
lock/unlock button. At this point, the battery is
locked in place;
2. To remove the battery, press the lock/unlock button
and pull out the battery;
Use VITO 20V lithium-ion batteries.
Charging the batteries
1. Place the battery in the charger in the same way as
you would place it in the appliance;
2. Plug the charger into the socket and let it charge.
Sometimes at the end of charging, both the battery and
the charger can be hot, which doesn't mean they
malfunction.
Let the battery cool down before putting it in the
electric chainsaw.
Guide bar and saw chain
Caution: The saw chain has very sharp cutting
edges. Wear protective gloves when fitting it.
Caution: Remove the batteries each time you
tension or change the saw chain. Always wear
protective gloves. To remove the cover, lift the lever
(11) and loosen the nut by turning it anticlockwise.
Attach the guide bar (2), by aligning its hole with
tensioning bolt.
Insert the chain (1) into the guide bar (2) and the
sprocket. Pay attention to the direction of the saw
chain.
While holding the guide bar, put the chain cover on and
tighten the nut, using the lever (11), until the bar is
pushed against the electric chainsaw body. Then turn
the saw chain tensioning knob (10) clockwise, leaving a
gap of 5-7mm between the bar and chain. When you
have this gap, tighten the nut firmly and put the lever
back into its original position.
Important: The saw chain must always have
proper tension. This prevents guide bar wear and
ensures a more perfect and safer cut.
30
OPERATING INSTRUCTIONS
While using the electric chainsaw you must consider
certain precautions and operating procedures in order
to avoid accidents, damage and to increase the
efficiency of the electric chainsaw:
▪ Always hold the electric chainsaw with both hands;
▪ Take extreme care when cutting off small branches
or bushes that may stuck the saw chain, they can
kickback against you making you losing balance and
get injured;
▪ If you try to cut trunks above the recommended size,
kickback can occur and cause accidents to the user;
▪ If you hear an unusual noise or the electric chainsaw
vibrates abnormally, stop working and identify the
cause;
▪ Never operate an electric chainsaw that is damaged;
On/off
Insert the batteries before starting the appliance!
When starting the appliance, the chain brake lever (3)
must be in its normal position, pressed towards the
front handle (4). The appliance is equipped with a
mechanism to prevent accidental starts.
To switch on, hold front the handle (4) with your left
hand, with the thumb of your right hand pressing the
safety trigger lock button (5) on the left-hand side of the
trigger. With the button still pressed, press the trigger
(7) and release the safety trigger button.
To switch off, release the trigger (the safety trigger lock
button returns to the locked position).
The noise the appliance makes when reducing speed is
normal and does not affect performance or service life.
Before starting the electric chainsaw motor, check
that the saw chain is not touching any object and
make sure that the brake is engaged.
Publicidad
