Publicidad
Idiomas disponibles
Idiomas disponibles
GB
2
Safety information
2.1
Possible hazards
Burn hazard!
The hook nozzle (1) and melted hot-melt adhesive can reach temperatures of
over 230 °C. Always wear heat protecting gloves if contact is unavoidable.
Irritating smells!
Xi
Hot-melt adhesives give off vapors which can have irritating smells. Ensure that
there is sufficient ventilation.
If the device is improperly used, isolated instances of mucous membrane
irritation could occur. You should contact a doctor immediately in such cases!
2.2
Information for safe operation
In order to protect against malfunctions and maloperation, always follow the following
information exactly:
• Remove combustible or heat-sensitive objects from the vicinity of the hook nozzle
(1).
• Only use the device when it is up to temperature.
• The warmed-up device must be placed on its stand (2). It must never be placed on
its side.
• Never operate the trigger (3) with excessive force.
• Protect the device from moisture and wetness (electric shock protection).
• Observe the instructions for Döllken hot-melt adhesive (processing error avoid-
ance).
• If working above head height, ensure that drops do not form to protect against
burns to personnel or working equipment.
• Always remove the power cable before carrying out any work to the device (mainte-
nance, cleaning).
• The device may only be operated on sockets with a protective earth.
• Any extension cables must also be provided with a protective earth. Check that the
extension cable is in good condition before use.
• Always remove the mains plug after use. Allow the device to cool down completely
before storing it.
• If you observe damage to the device or the power cable, remove the mains plug im-
mediately. Ensure that the device is checked immediately by an electrician. It may
only be put into operation once again after repairs have been correctly carried out
(see chapter 5).
Safety information
9
Publicidad
