Publicidad
WARNING!
1. Please make sure to turn o the power before starting the installation.
2. Installation must be performed by a qualified electrician.
3. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole lumi-
naire shall be replaced.
4. For Indoor use only
5. Before installation, you must carefully check the integrity of the product and accessories
6. When installed, products and flammable materials to ensure that at least 0.2m distance, lighting cannot be
installed in the zenith or heat wall, pay attention to low voltage and high voltage electrical wiring separately.
7. To ensure that the power cord has enough length, do not kink cables. Output cables should be laid separately and
at a distance from other cables.
This marking indicates that this
product should not be disposed of
with other household wastes.
Caution, risk of electric shock.
INSTALLATION INSTRUCTIONS
1.Choose the right position, drill two hole and insert the screw (make sure the distance between the holes is no less
than50mm, Less than bracket length)
2. Shrapnel point it at the hole and then install the screws
3.Press the lamp body firmly into the mounting buckle to fix the lamp body, Slide the lamp body along the mounting
buckle to the desired position as needed.
4. Connect the wiring, use insulating tape, and waterproof tape for insulation and waterproofing, turn the power ON
and test.
INSTALLATION DIAGRAM:
Publicidad
