Publicidad
Idiomas disponibles
Idiomas disponibles
Installing a 4-wire conduit
•
Aluminum building wire may be used but it must be rated for the correct amperage and voltage.
Connect wires according to this Step 4 depending on the number of wires.
•
Wire used, location and enclosure of splices, etc., must conform to good wiring practices and local codes.
Ground strap
Ground plate
Black
Wire
tips
Black
Gas Connection
WARNING
•
Turn off the gas-supply valve, and turn off power to the range at the circuit breaker or fuse box before
connecting the gas line.
•
Do not apply excessive pressure when tightening gas connections and fittings.
•
Do not use Teflon tape or plumber's putty on gas flex-line connections.
•
Maximum gas-supply pressure to the regulator must not exceed ½ psi (pounds per square inch) or 3.5 kPa.
•
The range and shut-off valve must be disconnected from the gas-supply piping for pressure testing that
exceeds ½ psi (3.5 kPa).
•
The range must be isolated from the gas-supply piping by closing the shut-off valve for pressure testing at
or below ½ psi (3.5 kPa).
•
Check all gas lines for leaks as instructed to avoid fire/explosions hazard. Do not check for leaks with a
flame.
NOTE
The gas-pressure regulator is factory set for the type of gas used with the range. To verify that the range is
compatible with the available gas, see the rating label (oven left door trim). Consult your dealer if the range is
incompatible with the supplied gas.
INSTALL_DOP36C86DLS_DA_DG68-01510A.indb 25
INSTALL_DOP36C86DLS_DA_DG68-01510A.indb 25
Red
White
Neutral
terminal
White
Red
Ground wire (Green)
1.
Loosen the 3 lower screws on the terminal block.
Remove and retain the ground screw and ground
plate.
2.
Cut and discard the ground strap. Do not discard any
screws.
3.
Insert the ground bare wire tip between the range
frame and ground plate (removed earlier), and secure
it with the ground screw (removed earlier).
4.
Insert the wire (white/neutral) tip through the
bottom center of the block opening.
5.
Insert the left and right wire tips into their respective
block openings.
6.
Tighten the screws to 35 – 50 in.-lbs.
(Any tighter may damage the wires.)
English 25
2023-02-23 오전 9:57:50
2023-02-23 오전 9:57:50
Publicidad
