IBEA IB-G5800 Manual Del Usuario página 27

8.3. CLEANING AND ADJUSTING SPARK PLUG:
8.3.1. If the spark plug is clogged with carbon, please clean it using a plug cleaner or
wire brush.
8.3.2. Always check electrode gap after cleaning.
Adjust gap to 0.03 inches (0.7mm to 0.8mm).
Please use original Ibea spare parts only.
8.4. CLEANING FUEL STRAINER:
Please note that dirt and water in the fuel are
removed by the fuel strainer.
8.4.1. Remove the strainer cup and clean it properly by
removing the water and dirt collected.
8.4.2. Clean the screen and strainer cup with gasoline.
8.4.3. Fasten the cup tightly to the main body and
ensure that there is no fuel leak.
8.5. FUEL HOSE REPLACEMENT:
WARNING:
Please take extreme caution when replacing the fuel hose as gasoline is extremely
ammable and dangerous. DO NOT SMOKE OR EXPOSE TO OPEN FLAMES whilst
doing it.
8.5.1. Please ensure that the fuel hose is replaced every 500 hours. Do not attempt to do
it whilst their fuel cock is open.
8.5.2. Please replace the fuel hose immediately should a leak develop or if the fuel hose
is perished.
52
8.6. CHECKING CARBON BRUSH:
8.6.1. When the brush becomes excessively worn its contact
pressure with the slip ring changes and causes a rough
surface on the slip ring resulting in irregular generator
performance.
8.6.2. Check the carbon brush every 500 hours or if the
generator performance is irregular.
8.6.3. If the brush is 0.2 inches (5mm) or less, please replace
it with a new one immediately.
0,7 / 0,8 mm
8.6.4. Remove the brush cover and disconnect the wire
before removing the carbon brush.
8.6.5. Carefully note the carbon brush direction and relative
position with the slip ring when installing a new brush.
9. TRANSPORTING AND STORAGE:
9.1. Before transporting the generator please ensure that the fuel cock is in the
"OFF" position.
CAUTION:
Contact with a hot engine or exhaust system can cause severe burns and or res, always
allow for the engine to cool down prior to transporting and or storing.
Always ensure that the generator is transported and or stored in a at horizontal
position. Tilting of the unit may cause fuel spillage which may result in a re.
9.2. Before storing the generator for an extended period of time please ensure that the
area of storage is free from excessive water, dust and humidity. Please follow the table
below:
BRUSH
BRUSH
HOLDER
BRUSH
HOLDER
SCREW
53