Publicidad
Idiomas disponibles
Idiomas disponibles
EN
BASIC OPERATION
Select the operating mode using the INPUT control on the amplifier front panel.
FM/USB/ INPUT
Select the mode with the MODE button:
FM RADIO MODE
-
Select FM mode on the amplifier
NOTE: to use this mode, you need to connect an antenna to FM ANT on the back panel.
-
Perform an automatic tuning of the stations to start using this mode by pressing
-
Once finished, you can select the station you wish to listen to from among those already set with
USB MODE
-
Connect the USB device.
-
Press
and
to change the song or
BLUETOOTH
MODE
®
-
Select Bluetooth
®
audio.
-
On your smartphone/tablet, turn on Bluetooth
-
Finally,select the music on your smartphone/tablet and start playback.
-
Press
and
to change the song or
NOTE: make sure your smartphone/tablet is loud enough to be heard through the amplifier. This allows you
to control the volume from the amplifier itself at a later time without having to operate any other equipment.
AUX 1/AUX 2 INPUTS
-
Select the desired mode by having the signal connected to the corresponding connector input on the
rear panel of the amplifier.
-
Activate the audio device (player, mixer, PC, smartphone, etc.) connected to the input to start playback.
NOTE: make sure that the signal from your audio device is loud enough to be heard through the amplifier.
This allows you to control the volume from the amplifier itself at a later time without having to operate any
other equipment.
CONNECTION
IMPORTANT: refrigerate the amplifier properly. To do this, make sure that the place where it is installed has
access to airflow and that the slots in the chassis are free of obstructions.
-
With the amplifier switched off, connect all audio sources AUX, CH, EMERG. INPUT. If you are going to
use the FM radio, you will need to connect an FM reception antenna.
-
Connect the speakers to the corresponding low impedance output* (4 Ω + COM) or 100 V line*
(100 V + COM) or zones* (Z1 + COM, Z2 + COM, Z3 + COM, Z4 + COM) or to the stereo line output (LINE
OUTPUT).
*IMPORTANT: for proper operation and performance of the equipment, use the correct power, impedance
and frequency limits. Before connecting to other equipment, be aware of the conditions required in a
HIGH IMPEDANCE (100 V) and LOW IMPEDANCE installation.. More information can be found at:
-
Check that the volume and gain controls are at minimum, connect the amplifier to power.
-
Turn on the amplifier and select input with the INPUT control and mode with the MODE button if FM/
USB/ input is selected.
-
Finally, adjust all volume and gain and equalization controls (BASS and TREBLE).
mode on the amplifier to pair your smartphone or tablet from which you want to send
fonestar.com/downloads/install_fonestar_es.pdf
to pause/resume playback.
mode, search for the NEXT device , and selectit.
®
to pause/resume playback.
- 4 -
.
and .
Publicidad
