REV Ritter L600S23PD Manual De Instrucciones página 9

GB
LED Turnlight (dimmbar)
Assembly and operating instructions
INTRODUCTION
Dear Customer,
We'd like to thank you for purchasing our product. Please read the following operating instructions thoroughly
before using this product for the first time and keep it handy for future reference (S1).
Please check the product before use for any damage.
PROPER USE
• Luminaire for wall and ceiling mounting on normally flammable surfaces in dry spaces.
• The product conforms to the appropriate European CE directives (S2).
• This product conforms to the appropriate European safety standards.
• The product is IP20 rated and suitable for use in dry interior spaces (S3).
• The product is intended exclusively for household use or similar purposes. It must not be used for commercial
purposes!
• The product may only be used only for the purpose for which it is intended, in accordance with this user manual!
• The product is not suitable for rough use (e.g. construction sites)!
• The product is not intended for use by persons (including children) whose physical, sensory or mental abilities
are limited or who lack experience and knowledge! These persons may only use the product if they are
supervised by a person responsible for their safety, or if they have been inducted into how to use the product!
The supervision and use of this product must be carried out by a responsible person!
GENERAL INFORMATION
• Handle this product carefully. It can be damaged by shocks, blows or by being dropped, even from a low height!
• Disconnect the product's mains power plug in the event of a fault during operation.
GENERAL SAFETY INSTRUCTIONS
• Please observe the technical specifications!
• Please follow this instruction manual and keep it in a safe place!
• Please pass on this instruction manual to a subsequent owner!
• Not to be used by children!
• Do not operate a defective product!
• Never look directly into the LED light source! The light spectrum transmitted may contain blue components (S4).
• Always allow to cool down sufficiently and for cleaning purposes disconnect the luminaire from the power supply
and secure the electric circuit against being switched on again.
• Install only on flat, stable surface!
• Use only in connection with a sufficiently fused 230V~ installation!
• Must not be used in areas that represent an explosion hazard (e.g. carpentry workshop, paintshop, or similar)!
• Do not use in the immediate vicinity of flammable materials!
• Do not immerse in water or other liquids!
• Do not operate with wet hands!
• Never undertake repairs yourself. Repairs may only be carried out by the manufacturer or an authorised service
representative.
• The light source in the luminaire is not replaceable. The entire luminaire must be replaced at the end of its
service life!
• Do not operate the product when covered (S5). This could lead to a dangerous buildup of heat!
• The product must remain freely accessible (also when in use)!
• A conversion or modification of the product affects product safety. Caution: risk of injury! A conversion or
modification of the product must not be carried out!
• Do not open the housing (S6)!
• If the cable is damaged, disconnect product from the power supply!
• De-energised only when the plug is pulled out (S7)!
• Do not operate the product's buttons with electrically conductive objects!
• Do not operate the product at, on or in the vicinity of open flames (e.g. candles)!
• To avoid damage, do not bend or knot cables over sharp edges or corners!
9