EZiclean iMap A100 Manual Del Usuario página 15

3. Place the water tank on the robot (only for the EZIclean® Aqua iMap version)
Fill the tank with cleaning solution diluted in water. Hang the microfiber on the velcro on the water tank and clip the tank under the robot.
Caution: Do not fill the water tank if you are not using the robot immediately, as the tank will empty on the spot.
4. Charging your device can be done in 2 ways.
A. Insert the adapter directly into the unit and plug the other end of the power supply into the socket, as shown in figure A below.
B. Press the «Return» button on the remote control or directly on the button of the robot, so that it automatically returns to its charging base,
as shown in figure B below.
5. Automatic reloading.
A. When the battery level of the device is too low, the robot automatically returns to its charging base.
B. Make sure that the charging base is powered on and remove any surrounding obstacles so that the robot does not get lost while searching for it.
C. In order to find its most suitable position, the robot can test the charging base 3-4 times before settling down for charging.
6. The different modes of your robot.
A. Active mode
All lights and buttons are lit and the appliance is in operation. Make sure that the switch is set to «I». Start the robot by pressing the «start / pause»
button on the remote control or directly on the robot button.
B. Sleep mode
The LED on the charging base is lit, the robot button is lit, the appliance is only in standby mode.
Press the «start / pause» button on the remote control once or directly on the robot button to start it.
C. Sleep mode
If the robot is not used for more than 25 seconds, it will automatically go into sleep mode.
Note:
To switch from sleep mode to standby mode, press the «start / pause» button on the remote control or directly on the button on the device. Press
a second time to start cleaning.