Descargar Imprimir esta página

Decathlon TW500 Manual Del Usuario página 18

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 43
Each week :
Check the tyre pressures. On the side of each wheel cover, you'll find the recommended tyre pressure.
A deflated tyre compromises the efficiency of the brakes and the fluidity of the wheelchair's
movements.
Check the efficiency of the quick removal devices [paragraph 6.3], clean them, and if necessary, oil the
axles and dowels with a li le grease to ensure that the wheels can be simply removed and replaced.
Each quarter:
Check for wear on the front wheels, which may alter the rear seat of the wheelchair if significantly
worn. In this case, proceed with replacing the wheels [par. 6.2].
Check the bearings on the front and rear wheels, and on the fork rota on. In this case, replace the
bearings [par. 6.2].
Grease the mobile parts, such as the quick removal axles of the wheels and the guides for the wheels.
We recommend using silicon oil as a grease, as it's effec ve and non-staining.
6.1
Replacing the tyre and air chamber
Disassembling the tyre and air chamber
Deflate the tyre
Install a special lever between the circle and the shoulder of the tyre, so that when the lever is lted,
the side of the wheel comes out (fig. 1 and 2)
Install another lever 100 mm from the previous point and repeat the opera on (fig. 3)
Slide the two levers around the whole circle to release the en re tyre.
Remove the air chamber, star ng with the side opposite the infla on valve (fig. 4)
Once the air chamber has been removed, you can easily remove the tyre to replace either or both of
them.
Assembling the air chamber and tyre
Remove the air chamber (deflated) in the tyre (fig. 5).
Insert the air chamber infla on valve into the whole intended for this purpose, located on the circle.
Around the whole circle, install the tyre, taking note of the direc on of the tyre, which indicates
whether it's the right or le drive wheel.
Install the opposite shoulder over the tyre, star ng from the point where the valve is, moving round in
both direc ons.
Insert the final part of the shoulder with the help of the levers intended for this, reversing the
instruc ons shown in Fig. 3, Fig. 2, and Fig. 1.
Inflate the tyre to the pressure indicated on its side.
FIG. 1
Wheel replacement (Fig. 6)
Unscrew and remove the "4" screws.
Remove axle "3" from its seat.
You can freely remove the wheel.
FIG. 2
6.2
Replacing the castors and bearings
FIG. 3
FIG. 4
17
FIG. 5

Publicidad

loading

Productos relacionados para Decathlon TW500