Publicidad
Idiomas disponibles
Idiomas disponibles
Ensure that the jump starter is only used by individuals who
are familiar with the instruction manual.
Inspect the jump starter before each use. If the jump starter
is damaged, do not operate it, it may cause an electric
shock to the user.
If the jump starter clamps are dirty, wipe them with a clean,
dry cloth.
Use the jump starter according to the safety instructions.
Failure to comply with the safety instructions may lead to
accidents and serious injury to the user.
When the jump starter is on, keep the contacts away from
current-carrying objects to avoid a short circuit.
The jump starter is compatible with any battery.
Your jump starter should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts.
Press the button to check the charge of the jump starter.
LEDs
0
Charge
0
25
(%)
When charging, the LED lights flash one by one.
The number of permanently-on LED lights indicate the
battery state of the jump starter. The LED lights all go out
when charging is paused or complete.
1. Insert the power adaptor into a socket;
2. Connect the USB cable to USB type-C port into the power
adaptor and the jump starter;
The LED lights will start flashing. As the battery charges,
the LED lights will stay on permanently.
3. The battery is fully charged when all the LED lights are
permanently lit;
4. Disconnect the jump starter from the charger.
1
2
3
50
75
1. Connect the smart cables to the jump starter and check
that the lights are still off;
2. Clamp the red cable to the positive (+) pole. Clamp the
black cable to the negative (-) pole.
3. Follow the instructions below:
• Permanent green light: the cables are correctly
connected, and the circuit is working properly;
• Flashing green light: the vehicle battery is low, press
the "BOOST" button. Wait for the green light to become
permanent. Start the engine within 30 seconds;
• Red light with audible alarm: the cables are incorrectly
connected and must be reversed. Wait for the green
light to become permanent;
• No lights or audible alarm: the vehicle battery must be
damaged. After confirming that the cables' connection
is correct, press the "BOOST" button. Wait for the green
light to become permanent. Start the engine within 30
seconds;
4. Start the vehicle;
5. When the vehicle starts, remove the smart cables from
the battery. Let the engine run.
1. Plug the cable into the USB port (Quick Charge) of the
jump starter;
2. Connect the other end of the cable to the device you want
to charge;
3. Press the ON/OFF power button to start charging.
1. Connect the cable to the jump starter output port;
2. Connect the other end of the cable to the device you want
4
to charge;
3. Press the ON/OFF power button to start charging.
100
Press the ON/OFF power button for 3 seconds to switch the
torch on. The jump starter has 3 light modes: normal, flash,
SOS. You can change between modes by pressing the
ON/OFF power button.
Publicidad
