altitude FARMDALE 24 Guía De Uso Y Cuidado página 14

HOW TO INSTALL YOUR CANOPY HOUSING
NOTE:
This step is applicable after the neccessary
wiring is completed.
Assemble canopy by rotating key hole slot in canopy over
shoulder screw in hanger bracket, taking care not to pinch the
wires. Tighten shoulder screw. Fully assemble and tighten
second shoulder screw that was previously removed. (Figure 1)
WARNING:
To avoid possible fire or shock, make sure
that the electrical wires are completely
inside the canopy housing and not pinched
between the housing and the ceiling.
Align the two oval shape open slots on the bottom of
the canopy screw cover with the two shoulder screw
heads on the canopy. Push up the canopy screw cover
until the screw heads engage the slots and rotate the
screw cover clockwise until it it attached to the bottom
of the canopy properly. (Figure 2)
How to Install Your Light Bulbs
1. Install light bulbs into sockets by threading in a clockwise
direction. (Figure 1)
NOTE: When relamping is required, USE ONLY MAX 5.5W,
TYPE ST19 OR ST58 DIMMABLE LISTED LED
(LIGHT) BULB.
CAUTION
RISK OF FIRE. USE ONLY LED LAMPS IN THIS
LIGHT KIT. INCANDESCENT AND HALOGEN LAMPS
MAY CAUSE SEVERE THERMAL DAMAGE.
Visit www.altitudefans.com/install for installation video tutorials and product support
14
LED Bulb
Figure 1