Publicidad
Idiomas disponibles
Idiomas disponibles
1. To turn the laser on, slide the "ON/OFF" switch (4) to the
"ON" position;
2. Slide the "ON/OFF" switch (4) to the "OFF" position.
Never leave the laser on with no one nearby. Always
switch the laser off after each use.
There are four projection modes for the laser lines. When
the laser is switched on, it projects by default all 3 lines with
the self-levelling function enabled.
To select the projection mode of the laser beam, press the
laser line selector button (6).
1. Press the button once to select the projection of the
horizontal laser line;
2. Press the button twice to select the projection of the
vertical laser line;
3. Press the button three times to select the projection of
the vertical transversal laser line;
4. If the laser level is projecting a vertical transversal line,
press the laser line selector button again to return to the
3-line projection simultaneously.
All projection modes can be selected with or without self-
levelling function activated.
Self-levelling:
The self-levelling automatically compensates on uneven
surfaces of ± 4° slope.
The laser automatically adjusts the levelling whenever
vibrations or position changes have occurred during
operation. After any levelling adjustment, to avoid errors,
you must check the position of the laser beams in relation
to the reference points.
If self-levelling cannot be performed because the laser's
base has an inclination greater than 4° to the horizontal,
the self-levelling LED indicator turns red.
If self-levelling range is over ± 4°, the self-levelling function
is disabled.
1. Place the laser on a level, stable surface or fix it on a
stand;
2. Slide the "ON/ON" switch (4) to the "ON" position;
3. Press the laser line selector button (6) according to the
desired laser beam projection mode;
4. Wait until the automatic self-levelling LED indicator (5)
turns green and the projected laser lines are stable. At
this point, the 3X360º self-levelling cross-line laser is
ready for operation.
Without self-levelling:
When self-levelling is deactivated, the laser lines are
locked but not calibrated and are therefore no longer self-
levelling. You can hold the laser with your hands, place it
on an inclined surface or supports.
1. Slide the "ON/OFF" switch 4) to the "OFF" position;
2. Press the laser line selector button (6) according to the
desired laser beam projection mode;
3. While using the laser without self-levelling function, the
self-levelling LED indicator (5) turns red.
The laser does not require any additional maintenance.
However, for a continuous and trouble-free operation, you
must perform regular cleaning and proper maintenance
tasks.
Before carrying out any checking, maintenance or cleaning
work, remove the batteries from the laser.
Cleaning
Clean all laser components after each use. Wipe the 3x360º
self-levelling cross-line laser with a clean, damp cloth or
blow it with low pressure compressed air. Careful handling
protects the product and extends its service life.
Storage
When not in use, store the laser in a dry, clean place, free
of corrosive smoke and out of children's reach. Remove the
battery when storing the appliance.
Publicidad
