MD SPORTS 12702 Instrucciones De Armado página 4

#1
MAIN FRAME
1 Piece
#5
FELT PAD
2 Pieces

!



1. Open the carton of your new Table Top Hockey near where you will play. Remove all the contents from inside the
carton and verify that you have all listed parts as shown on the Parts Identifier.
2. Place the Main Frame (#1) on a clean, flat surface. And then
stick them at the bottom of the
3. Attach the Goals (#4) to each end of the table using the Screws (#6) as shown in FIG. 1.
4. Tear off the backside paper of the Felt Pad (#5) and stick them at the bottom of the Pusher (#2) as shown in FIG.2.
5. Remove the battery cover (underneath the table) and insert 6 AA Batteries (not included) into battery box. Turn it on
to start the game.
Underside
the table
FIG.1A
#8
12702 PARTS LIST
#2
PUSHER
2 Pieces
#6
10mm ROUND
HEAD SCREW
4 Pieces
Assembly Instructions
Side Apron as shown in FIG.1A.
FIG.1
#4
#6
#3
ROUND PUCK
2 Pieces
Pre-installed
#7
MOTOR
1 Piece
t ear off the backside paper of the EVA Pad (#8) and
#5
FIG.2
3
#4
GOAL
2 Pieces
#8
EVA PAD
4 Pieces
#6
#2